Installation Instructions for Decorative Stickers without Transfer Tape

Required Materials:

• The decorative sticker
• A felt squeegee (or a rigid card wrapped in a soft cloth to avoid scratching)
• A clean, dry cloth
• Painters tape (recommended)
• A measuring tape or a ruler

1. Prepare the surface

Ensure that the surface where you will apply the sticker is clean, smooth, dust-free, and completely dry. Use a clean, dry cloth to remove any dirt, debris, or moisture.

2. Position the sticker

Place the sticker in the desired location on the surface. If necessary, use painters tape to temporarily hold it in place while you check the alignment.

Use a ruler or measuring tape to ensure the sticker is straight.

3. Apply the sticker

Once the sticker is properly positioned, start peeling back a small portion of the backing paper, exposing the sticker.

While holding the sticker in place, begin to apply it to the surface, gradually peeling off the rest of the backing paper as you go.

4. Smooth the sticker

Use the felt squeegee to smooth the sticker as you apply it. Press gently but firmly, working from the center outward to avoid creating air bubbles.

5. Eliminate air bubbles

If air bubbles appear under the sticker, continue smoothing gently with the felt squeegee. For small bubbles, pierce them carefully with a pin or needle, then smooth again.

6. Remove the painters tape

If you used painters tape to hold the sticker, gently remove it once the application is complete.

Additional Tips:

• Use a felt squeegee to avoid damaging or scratching the surface of the sticker.
• Apply the sticker at room temperature for better adhesion.
• Ensure the sticker is fully smoothed before allowing it to fully adhere to the surface.

That's it! Your decorative sticker has been successfully applied!